Research Article

Effect of annealing conditions on the magnetic, optical and photocatalytic properties of the perovskite-type material La1-x(Bix)FeO3-δ

Ibrahim A.1*, Bice S. Martincigh2, Sreekantha B. Jonnalagadda2
1 Department of Chemistry, Ahmadu Bello University, Zaria
2 School of Chemistry and Physics, University of KwZulu-Natal Westville Campus, South Africa
* Corresponding author: Ibrahim.abdulkadir@gmail.com
Published: Jun, 2016
Pages: 106-112

Abstract

Novel perovskite-type nanomaterials with the composition La1-x(Bix)FeO3-δ (where x = 0.5 and 0.2) were synthesized by using a modified citric acid sol-gel route and annealed at 900 °C in (1) in air (LB0.5FO-air and LB0.2FO-air), and (2) in Argon atmosphere (LB0.5FO-Ar and LB0.2FO-Ar). Scanning electron microscopy and powder X-ray diffraction analysis of the powders showed that they contain crystalline perovskite-type nanoparticles with crystallite sizes 37-41 nm. The lattice parameters, after refinement, showed that the particles crystallized in an orthorhombic structure. The BET specific surface areas (SSA) ranged between 1.76-4.37 m2 g -1 with powders synthesized under argon having the higher SSAs. Vibrating sample magnetometer analysis of the hysteresis loop showed a slightly higher magnetization value for the samples synthesized in air. Photoluminescence spectroscopy showed that the powders were all active in the visible region and could be useful for visible light photodegradation of organic dyes. The powders were all screened for photocatalytic activity against an organic dye (Rhodamine B) in the visible region of the solar spectrum and the photocatalytic activities were good for powders synthesized in argon, in addition, a mineralization of up to 80% was achieved after 3 hrs of photodegradation for these powders as well. The materials, therefore, show good potential for the photocatalytic degradation of organic pollutants and photocatalyst recovery after photodegradation.

Keywords

Perovskites Magnetisation Photoluminescence Photocatalytic Activities

References

  1. BOUYSSIERES, L., SCHIFFERLI, R., URBINA, L., ARAYA, P. & PALACIOS, J. M. 2005. STUDY OF PEROVSKITES OBTAINED BY THE SOL-GEL METHOD. Journal of the Chilean Chemical Society, 50, 407-412.
  2. CHUNG, C.-Y., CHANG, Y.-S., CHEN, G.-J., CHUNG, C.-C. & HUANG, T.-W. 2008. Effects of bismuth doping on the dielectric properties of Ba(Fe0.5Nb0.5)O3 ceramic. Solid State Communications, 145, 212-217.
  3. GHASDI, M., ALAMDARI, H., ROYER, S. & ADNOT, A. 2011. Electrical and CO gas sensing properties of nanostructured La1-xCexCoO3 perovskite prepared by activated reactive synthesis. Sens. Actuat. B, 156, 147-155.
  4. GONZALEZ GARCIA, F., RICCARDI, C. S. & SIMOES, A. Z. 2010. Lanthanum doped BiFeO3 powders: Syntheses and characterization. Journal of Alloys and Compounds, 501, 25-29.
  5. JIANG, J., ZOU, J., ANJUM, M. N., YAN, J., HUANG, L., ZHANG, Y. & CHEN, J. 2011. Synthesis and characterization of wafer-like BiFeO3 with efficient catalytic activity. Solid State Sciences, 13, 1779-1785.
  6. JUNPLOY, P., THONGTEM, S. & THONGTEM, T. 2013. Photoabsorption and photocatalysis of SrSnO3 produced by a cyclic microwave radiation. Superlattices and Microstructures, 57, 1-10.
  7. LANTTO, V., SAUKKO, S., TOAN, N. N., REYES, L. F. & GRANQVIST, C. G. 2004. Gas Sensing with Perovskite-like Oxides Having ABO3 and BO3 Structures. Journal of electroceramics, 13, 721-726.
  8. LIANG, Y.-Q., DI, N.-L. & CHENG, Z.-H. 2005. Charge-disproportionation-induced magnetic glassy behavior in La0.5Ca0.5FeO3-delta. Physical Review B, 72, 134416.
  9. MACHIDA, M., YABUNAKA, J.-I. & KIJIMA, T. 2000. Synthesis and Photocatalytic Property of Layered Perovskite Tantalates, RbLnTa2O7 (Ln = La, Pr, Nd, and Sm). Chemistry of Materials, 12, 812-817.
  10. MAGUIRE, E., GHARBAGE, B., MARQUES, F. & LABRINCHA, J. 2000. Cathode materials for intermediate temperature SOFCs. Solid State Ionics, 127, 329-335.
  11. PAIK, D. S., PARK, S. E., SHROUT, T. R. & HACKENBERGER, W. 1999. Dielectric and piezoelectric properties of perovskite materials at cryogenic temperatures. Journal of Materials Science, 34, 469-473.
  12. PARKIN, I., KOMAROV, A. & FANG, Q. 1996. Alternative solid state routes to mixed metal oxides (LnCrO3, LnFeO3). Polyhedron, 15, 3117-3121.
  13. PEEL, M. D., ASHBROOK, S. E. & LIGHTFOOT, P. 2013. Unusual Phase Behavior in the Piezoelectric Perovskite System, LixNa1-xNbO3. Inorganic Chemistry, 52, 8872-8880.
  14. RAMAJO, L., CASTRO, M., DEL CAMPO, A., FERNANDEZ, J. & RUBIO-MARCOS, F. 2014. Influence of B-site compositional homogeneity on properties of (K0.44Na0.52Li0.04)(Nb0.86Ta0.10Sb0.04) O3-based piezoelectric ceramics. Journal of the European Ceramic Society, 34, 2249-2257.
  15. SKINNER, S. J. 2001a. Recent advances in perovskite-type materials for SOFC cathodes. Fuel Cells Bulletin, 4, 6-12.
  16. SKINNER, S. J. 2001b. Recent advances in Perovskite-type materials for solid oxide fuel cell cathodes. International Journal of Inorganic Materials, 3, 113-121.
  17. TANG, J., ZOU, Z. & YE, J. 2007. Efficient Photocatalysis on BaBiO3 Driven by Visible Light. The Journal of Physical Chemistry C, 111, 12779-12785.
  18. WANG, L., WANG, D., HUANG, H., HAN, Z., CAO, Q., GU, B. & DU, Y. 2009. The magnetic properties of polycrystalline Bi(1-x) SrxFeO3 ceramics. Journal of Alloys and Compounds, 469, 1-3.
  19. WILLIAMS, I. 2001. Environmental Chemistry; A Modular Approach. Wiley. 1 ed. UK: John Wiley & Son, Ltd.
  20. YU, K., YANG, S., LIU, C., CHEN, H., LI, H., SUN, C. & BOYD, S. A. 2012. Degradation of Organic Dyes via Bismuth Silver Oxide Initiated Direct Oxidation Coupled with Sodium Bismuthate Based Visible Light Photocatalysis. Environmental Science & Technology, 46, 7318-7326.
  21. ZHU, J., LI, H., ZHONG, L., XIAO, P., XU, X., YANG, X., ZHAO, Z. & LI, J. 2014. Perovskite Oxides: Preparation, Characterizations, and Applications in Heterogeneous Catalysis. ACS Catalysis, 2917-2940.
How to Cite

A., I., Martincigh, B. S., & Jonnalagadda, S. B. (2016). Effect of annealing conditions on the magnetic, optical and photocatalytic properties of the perovskite-type material La1-x(Bix)FeO3-δ. Nigerian Journal of Materials Science and Engineering, 7(1), 106-112.

I. A., B. S. Martincigh, and S. B. Jonnalagadda, "Effect of annealing conditions on the magnetic, optical and photocatalytic properties of the perovskite-type material La1-x(Bix)FeO3-δ," Nigerian Journal of Materials Science and Engineering, vol. 7, no. 1, pp. 106-112, June 2016.

Share this article:
Facebook X / Twitter LinkedIn
Download PDF Back to Articles