Research Article

Effect of chemical modification on the flow and electrical properties of neem oil derivatives

ABDELMALIK A. A1*, Umar S.2, Sadiq U.1
1 Department of Physics, Ahmadu Bello University Zaria, Nigeria
2 cccc
* Corresponding author: aaabdelmalik@gmail.com
Published: Jun, 2016
Pages: 51-58

Abstract

Seed oil has been proposed as alternative base fluid for drilling mud but its stability to oxidation is still an issue to deal with. This paper reports the influence of stabilizing neem oil through chemical modification on its flow and electric conduction properties. Ester derivatives were produced from laboratory purified neem oil. The purified neem oil (PNO) was epoxidized to convert the double bonds to epoxy rings in order to eliminate the weak pi-bonds that are susceptible to oxidation. The derived products from these controlled reactions were verified using Fourier Transform Infrared (FTIR) spectroscopy. The viscosity of the epoxy neem was found to have increased. Glycerol was then removed from the epoxy oil to produce alkyl ester of epoxy neem oil. This reduced the viscosity of the epoxy oil. The mid frequency dielectric response of the PNO and its derivatives are related to ionic conduction. PNO has an electrical conductivity of 1.26 × 10-9 S·m-1 at 20ºC; this is about 100 times higher than the conductivity of diesel oil used as base oil for drilling fluid. The bulk conductivity is thermally activated (activation energy = 0.31 eV) and influenced by the liquid viscosity. A higher conductivity was observed for the ester derivatives compared to that for PNO and this may be attributed to polarization of suspended nano impurities. The obtained results support the proposition that suspension of conducting nano-particles in the neem oil derivatives will pave way for the production of a suitable base liquid that will provide lubrication and electric current path for a sustainable oil-based drilling fluid for offshore drilling

Keywords

Drilling fluid Neem oil Epoxidation Sustainable materials electrical conductivity

References

  1. Abdelmalik A.A. (2012). The feasibility of a vegetable oil-based fluid as electrical insulating oil, PhD Thesis, University of Leicester UK.
  2. Abdelmalik A.A., Abbott A.P., Fothergill J.C., Dodd S. & Harris R.C. (2011). Synthesis of a base-stock for electrical insulating fluid based on palm kernel oil, Industrial Crops and Products 33, 532-536.
  3. Bartnikas R. (1987). Alternating-current loss and permittivity measurements in engineering dielectric, Vol. IIB, Electrical Properties of Solid Materials: Measurement techniques, R. Bartnikas, 52-123, ASTM Publication.
  4. Caenn R., Darley H.C.H., Gray G.R. (2011). Composition and properties of drilling and completion fluids, 6ed, Gulf Professional Publishing, USA.
  5. Cheung P., Hayman A., Laronga R., Cook G., Flournoy G., Hansen S., Lamb M., Li B., Larsen M., Orgren M., Redden J. (2001). A clear picture in oil-base muds, Schlumberger Oilfield Review, 13(4), 2-27.
  6. Clean Water Team (CWT). (2004). Electrical conductivity/salinity Fact Sheet, FS-3.1.3.0(EC). in: The Clean Water Team Guidance Compendium for Watershed Monitoring and Assessment, Version 2.0. Division of Water Quality, California State Water Resources Control Board (SWRCB), Sacramento, CA.
  7. Dasa Rao C. J., Seshadri T. R. (1942). Fatty acids of neem oil, Proceedings of the Indian Academy of Sciences - Section A, 15(3), 161-167.
  8. Esteban B., Riba J., Baquero G., Rius A., Puig R. (2012). Temperature dependence of density and viscosity of vegetable oils, Biomass and Bioenergy 42, 164 -171.
  9. Gardener L., Moon F.G. (1983). The relationship between electrical conductivity and temperature of aviation turbine fuels containing static dissipator additives, Division of Mechanical Engineering, National Research Council Canada.
  10. Growcock F.B., Patel A.D. (2011). The revolution in non-aqueous drilling fluids, AADE National Technical Conference and Exhibition, Texas.
  11. Hwang H. S. and Erhan S. Z. (2001). Modification of epoxidized soybean oil for lubricant formulation with improved oxidative stability and low pour point, J. Am. Oil Chem. Soc. 78, 1179-1184.
  12. Kestin J, Sokolov M., Wakeham W.A. (1978). Viscosity of liquid water in the range -8°C to 150°C, J. Phys. Chem. Ref. Data, 7(3), 941-948.
  13. Massey B., Ward-Smith J. (2006). Mechanics of fluids, 8ed, Taylor and Francis.
  14. McShane C.P., Gauger G.A., Luksich J. (1999). Fire resistant natural ester dielectric fluid and novel insulation system for its use, Proceedings of IEEE/PES Transmission and Distribution Conference.
  15. Neff J.M., McKelvie S. and Ayers R.C. (2000). Environmental impacts of synthetic based drilling fluids. Report prepared for MMS by Robert Ayers & Associates, Inc. August 2000. U.S. Department of the Interior, Minerals Management Service, Gulf of Mexico OCS Region, New Orleans, LA. OCS Study MMS 2000-064.
  16. Oommen T.V. (2002) Vegetable oil for liquid-filled transformers. IEEE Electr. Insul. Mag. 18, 6-11.
  17. Silverstein R.M., Webster F. X. & Kiemle D. J. (2005). Spectrometric identification of organic compounds, John Wiley & Sons Inc.
  18. Zanten R.V. (2014). Electrically conductive oil-base drilling fluids, US Patent US8763695 B2.
How to Cite

A, A. A., S., U., & U., S. (2016). Effect of chemical modification on the flow and electrical properties of neem oil derivatives. Nigerian Journal of Materials Science and Engineering, 7(1), 51-58.

A. A. A, U. S., and S. U., "Effect of chemical modification on the flow and electrical properties of neem oil derivatives," Nigerian Journal of Materials Science and Engineering, vol. 7, no. 1, pp. 51-58, June 2016.

Share this article:
Facebook X / Twitter LinkedIn
Download PDF Back to Articles